Follow

Why does the monitor display erroneous pressures for all of my tyres?

The Monitor has the capability of offering pressure values in alternate Metric, as well as PSI units. The observation of the erroneous pressure values for all locations can sometimes be the first indication that the Monitor has been placed into an alternate Metric pressure unit. Units can be selected/changed by unplugging the Monitor, then re-powering while simultaneously holding down the “ON” button. Thealternate unit abbreviations will briefly show in the Monitor’s read-out window each time you plug in the Monitor. For North American PressurePro users, if the Monitor is not reading out in “PSI”, change the Metric readout per the above procedure, until you observe a “PSI” read-out. Wait 5 minutes for all of the Sensors to send updated readings.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments